REPLACE CLOVER EFI WITH ALPPLE UEFI HOW TO
REPLACE CLOVER EFI WITH ALPPLE UEFI INSTALL

I wonder if itвЂ™s the reason for the bad performance of the previously SATA 3 Gbps drives. They still work mostly fine so IвЂ™ll be using them on less important systems until they finally die.ДЄs a bonus, with SSDs out of the way, all of my hard drives are now running SATA 6 Gbps. In the end, it took a bit over 6 hours to figure out and set up everything.ДЄnd now I have two spare SSDs.

plist format sure is great.ДЄ few reboot tests later, everything seems to finally work reliably. That also took quite a while to finally figure out. I didnвЂ™t have plist editor so I made some mistakes when editing the file. Volume IDs were obtained by pressing F2 on the boot screen and reading the generated log located at efi/clover/misc. I suspect if itвЂ™s just for Windows or Linux, it would work right away? I donвЂ™t have either installed so I donвЂ™t know рџ¤·вЂЌв™ЂпёЏДЄfter trolled by commented key looking like normal key, I ended up with this configuration: Unfortunately Clover doesnвЂ™t natively support FreeBSD so additional steps were needed. Some of them are probably not needed but it took so long already so itвЂ™ll be homework for another time. Here are the list of modules I copied over: I copied over a bunch of extra modules which then finally allowed me to see the Clover boot screen as expected.

REPLACE CLOVER EFI WITH ALPPLE UEFI INSTALL

I had chosen to install from a USB key, but what I had forgotten is that. It was fine for the desktop system I tested previous day but apparently it wasnвЂ™t good enough for booting from this specific system. Guide Gigabyte BRIX-s using Clover UEFI (GB-BXi5H-4200) RehabMan said: Audio.

Many hours later, I learned I needed more than just the basic boot loader for that specific system. I plugged in the Clover UEFI and booted from it and then I gotвЂ¦ nothing. As expected, the bios didnвЂ™t detect any of the NVMe, much less have option for booting from them.

REPLACE CLOVER EFI WITH ALPPLE UEFI HOW TO

With the new drives filled and set up as system drives, I then proceeded figuring out how to boot the thing. I think I spent at least an hour figuring this out? In the end, it seems like a full power cycle by disconnecting PSU was the most reliable way to get everything detected correctly.ДЄs everything was finally detected correctly, I mirrored the system drive from old SSDs to the NVMeвЂ™s. At least the last slot seem to detect everything so I tested all four cards (SSD x2, SAS, ethernet) on that slot and they were all detected and operating correctly. Not only that, one of the drives wasnвЂ™t detected either.ДЄfter some more swapping slots, none of the cards were detected. Meanwhile, once I turn the system back on, the network adapter was gone. That was pretty annoying and after fiddling around a bit it turned out the slot wasnвЂ™t quite aligned correctly and so a bit of bending was needed. Then come installing them to the server, one of them didnвЂ™t quite go in cleanly. Installing the drives to the adapters was easy.

Replace clover efi with alpple uefi